Each top burner valve has a small screw inside its shaft that can be adjusted to provide a low simmer. One detail that’s commonly overlooked on these is the simmer settings. While searching the web for answers, I came across this text on : They asked a lot of questions about the conversion – had I changed the orifices, had I changed the regulator’s pressure, did I adjust the air flow – and suggested I call an appliance repair service to take a look at it. I called Whirlpool to ask if there was any way to adjust the burners to give a lower flame. That’s far too much heat for slow cooking for rice or stews. This, the lowest flame, would still sustain a full boil in a large pot. When we were done, everything worked fine, except the range burners would not go lower than this: The installation instructions walked us through the process, which included changing the pressure of the regulator valve, installing smaller orifices in each of the burners, and adjusting the air flow for proper combustion. ![]() ![]() This stove required a conversion from natural gas to propane (LP). We recently installed a stove in our home.
0 Comments
Leave a Reply. |